Brushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor

Brushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor
SKU
Motor-01
PKR2,650.00
Sold By
Buytronics Pakistan
0 / 5
0% positive feedback (0 ratings)
Price :
 (0/5)
Value :
 (0/5)
Quality :
 (0/5)
In stock

Brushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor

FEATURES:

  1. DC brushless motor driver board.
  2. Operating voltage: DC 12V to 36V; operating current ≤15A.
  3. With speed regulation function, 0.1V-5V speed voltage.
  4. Stall protection, over-current protection, enable control, steering control and speed control signal.

SPECIFICATIONS:

  1. Operating Voltage: DC12-36V
  2. Operating Current: ≤15A
  3. Drive Power: ≤500W
  4. Speed Voltage: 0.1V-5V
  5. Operating Temperature: -40~85°C
  6. Humidity: ≤90%RH
  7. Stall Protection: Yes
  8. Enable Control: Yes
  9. Over-current Protection: Yes
  10. Steering Control: Yes
  11. Speed Control Signal: Yes

PIN CONFIGURATIONS:

Power terminal OUT:

  • VCC (positive power supply)
  • GND (negative one)
  • MC (motor phases W)
  • MB (motor phases V)
  • MA (motor phases U)

SET for the control side:

  • GND  control terminal ground
  • VR   the governor end 0-5V(corresponding to 10% of motor speed - 100%)
  • ZF   reversing control(connected to 5V or ground can change the motor rotation direction)
  • M   tachometer pulse output(depending on the number of motor poles corresponding to the number of pulses per revolution of the output number)
  • EL  enable control terminal(connected to 5V or ground running then 5V, grounding the motor stops)

HALL for the Hall terminals:

  • 5V, Hall power positive
  • Ha, Hall signal
  • Hb, Hall signal
  • Hc, Hall signal
  • GND, Hall negative
Control terminal for SET: 
  • The motor speed control wiring methods:Available potentiometer system speed can also be controlled by MCU Control, when the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage more high speed faster.
Hall Signal inputs for Hall:
  • Wiring diagram is shown, one corresponding to the HA, HB, HC and on the motor, 5V power supply connected to the motor Hall signals positive, GND power supply negative signal to motor Hall.
  • Note:Due to different motor manufacturers to make the Hall of Hall line order does not necessairly follow the line on the board to match the sequence, need to be adjusted, please parents who pay atteneion.If  the line sequence is wrong, does not boot properly, current, or start other phenomena not open, forced to use the drive plate will burn.

PACKAGE INCLUDES:

  1. 1 X  Brushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor
Write Your Own Review
Write a Review forBrushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor